Secure Computing SG550 Especificações Página 13

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 64
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 12
Front Panel 13
Hardware Overview
Physical Interface Module Slots
Physical interface modules (PIMs) let you add Ethernet and WAN interfaces to your
SSG 500-series device. To install and remove PIMs, see “Replacing a PIM” on
page 46. For more information about installing and configuring PIMs, see the PIM
and Mini-PIM Installation and Configuration Guide.
Table 4 shows the PIM types you can install in the slots of an SSG 520 device. The E
located on some of the slots identifies where you can install enhanced PIMs
(ePIMs).
Table 5 shows the PIM types you can install in the slots of an SSG 550 device. The E
located on some of the slots identifies where you can install enhanced PIMs
(ePIMs).
USB Ports
The USB ports on the front panel of an SSG 500-series device accept a universal
serial bus (USB) storage device.
The USB ports let you transfer data such as device configurations, image keys, and
ScreenOS software between a USB storage device and the internal flash storage of
the security device. The USB ports support USB 1.1 and USB 2.0 specifications.
You can also log messages to a USB storage device. For more information about
logging, refer to the Administration volume of the Concepts and Examples ScreenOS
Reference Guide.
CAUTION: PIMs are not hot-swappable. Always switch off the device before
inserting or removing PIMs.
Table 4: PIM Slots, SSG 520
Slot PIM Types Slot PIM Types
1 WAN PIM or uPIM only 4 WAN PIM or uPIM only
2 WAN PIM or uPIM only 5 WAN PIM or uPIM only
3 WAN PIM, uPIM or ePIM 6 WAN PIM, uPIM or ePIM
Table 5: PIM Slots, SSG 550
Slot PIM Types Slot PIM Types
1 WAN PIM or uPIM only 4 WAN PIM or uPIM only
2 WAN PIM, uPIM or ePIM 5 WAN PIM, uPIM or ePIM
3 WAN PIM, uPIM or ePIM 6 WAN PIM, uPIM or ePIM
NOTE: When you install PIMs with Small Form-factor Pluggable (SFP) interfaces, Juniper
strongly recommends the use of Juniper SFP transceivers. Juniper cannot
guarantee correct operation if non-Juniper transceivers are used. The transceiver
type can be different in each port, as long as a supported part number is used.
Vista de página 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Comentários a estes Manuais

Sem comentários