Secure Computing SG550 Manual do Utilizador descarregar pdf (Página 274)

System

270

Warning

Before restoring your SG unit to its default factory settings via the web management

console or reset button, it is strongly recommended that you create a back up of your

configuration. Refer to the Save/Restore section earlier in this chapter for details.

Reboot device

Click Reboot Now to have the SG unit to perform a soft reboot. It usually takes around

10 seconds before it is up and running again.

If you have enabled bridging, the SG unit may take up to 30 seconds to reboot. Any

shared printers take 30 seconds to become available, during which time print jobs are not

accepted.

Erase configuration

To erase your SG unit’s configuration and return to the factory default settings, click

Erase Configuration. This is useful if you want to reconfigure the device form scratch

after an upgrade, or want to redeploy the device into a different environment.

Reset button

Another method to clear the SG unit’s stored configuration information is by pushing the

reset button on the back panel of the SG unit twice. A bent paper clip is a suitable tool

for performing this procedure.

This is particularly useful should the SG unit become uncontactable, e.g. due to

misconfiguration.

Pushing the reset button twice clears all stored configuration information, reverts all

settings to the factory defaults, and reboots the SG unit.

Note

When the SG unit reboots, it has an IP address of 192.168.0.1, netmask 255.255.255.0.

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 296 297

Sem comentários

Secure Computing SG550 Manual do Utilizador Página 274